30H3S3GML
Responsible destination highly loaded parts with a wall thickness of 30 mm, which are requirements of high strength and toughness sufficient
Responsible destination highly loaded parts with a wall thickness of 30 mm, which are requirements of high strength and toughness sufficient
Standard | Fe, % | Si, % | Mn, % | Cr, % | P, % | C, % | S, % | Mo, % |
---|---|---|---|---|---|---|---|---|
Standard | Fe, % | Si, % | Mn, % | Cr, % | P, % | C, % | S, % | Mo, % |
GOST 977-88 | 91.43–92.91 | 2.8–3.2 | 0.7–1.2 | 2.8–3.2 | < 0.02 | 0.29–0.33 | < 0.02 | 0.5–0.6 |
Rolling | Standard | Size, mm | Tension | Classifiers | $$\sigma _{U}$$, $$MPa$$ | $$\sigma_{P}$$, $$MPa$$ | $$\epsilon_L$$, % | $$\psi$$, % | $$KCU\cdot 10^{3}$$, $$\frac{J}{m^2}$$ | Treatment |
---|---|---|---|---|---|---|---|---|---|---|
Rolling | Standard | Size, mm | Tension | Classifiers | $$\sigma _{U}$$, $$MPa$$ | $$\sigma_{P}$$, $$MPa$$ | $$\epsilon_L$$, % | $$\psi$$, % | $$KCU\cdot 10^{3}$$, $$\frac{J}{m^2}$$ | Treatment |
Castings | GOST 977-88 | 1766 | 1472 | 4 | 15 | 196 |
Standard | Description |
---|---|
Standard | Description |
GOST 977-88 |
Parameter | Units of measurement | Description |
---|---|---|
Parameter | Units of measurement | Description |
$$\sigma _{U}$$ | $$MPa$$ | Ultimate tensile strength |
$$\sigma_{P}$$ | $$MPa$$ | Proportionality limit |
$$\epsilon_L$$ | % | Elongation at break (longitudinal) |
$$\psi$$ | % | Reduction in cross section on fracture |
$$KCU\cdot 10^{3}$$ | $$\frac{J}{m^2}$$ | Impact toughness |