AD1 (1013)

For the manufacture of semi-finished products (sheets, tapes, strips, plates, profiles, panels, rods, tubes, wire, stampings and forgings) by hot or cold deformation, as well as ingots and slabs

Classification

Country Section Category
CIS, Russia, Ukraine Aluminum, aluminum alloys Technical aluminum

Chemical composition

Standard Fe, % Si, % Mg, % Mn, % Ti, % Cu, % Zn, % Al, %
GOST 4784-97 < 0.3 < 0.3 < 0.05 < 0.025 < 0.15 < 0.05 < 0.1 < 99.3

Information on suppliers

Physical characteristics

Temperature, °C $$E\cdot 10^{9}$$, $$MPa$$ $$\alpha\cdot 10^{6}$$, $$K^{-1}$$ $$\varkappa$$, $$\frac{W}{m\cdot K}$$ $$\rho$$, $$\frac{kg}{m^3}$$ $$R\cdot 10^{-6}$$, $$\Omega\cdot m$$
20 71 2710 0.0292
100 24 226
200 25.6

Mechanical properties at 20 °C

Rolling Standard Size, mm Tension Classifiers $$\sigma _{U}$$, $$MPa$$ $$\epsilon_L$$, % Treatment
Trumpet 60 20
Trumpet annealing 60–110 20
Trumpet cold-work 100–110 4–5
Round GOST 21488-97 60 25
Tape cold-work 130–145 3–5
Tape annealing 60 20–30
Profile 59 20
Profile cold-work 98

Analogues

USA
AA1135

Standards

Standard Description
GOST 4784-97

Description of chemical elements

Element Units of measurement Description
Fe % Iron
Si % Silicon
Mg % Magnesium
Mn % Manganese
Ti % Titan
Cu % Copper
Zn % Zinc
Al % Aluminium

Description of physical characteristics

Parameter Units of measurement Description
$$E\cdot 10^{9}$$ $$MPa$$ Elastic modulus
$$\alpha\cdot 10^{6}$$ $$K^{-1}$$ Coefficient of thermal (linear) expansion (range 20°C–T)
$$\varkappa$$ $$\frac{W}{m\cdot K}$$ Coefficient of thermal conductivity (the heat capacity of the material)
$$\rho$$ $$\frac{kg}{m^3}$$ The density of the material
$$R\cdot 10^{-6}$$ $$\Omega\cdot m$$ Electrical resistivity

Description of mechanical properties

Parameter Units of measurement Description
$$\sigma _{U}$$ $$MPa$$ Ultimate tensile strength
$$\epsilon_L$$ % Elongation at break (longitudinal)