VT1-2
For the manufacture of semi-finished products (sheets, tapes, foil, strips, plates, rods, profiles, pipes, forgings and stamped blanks) by the method of deformation, as well as ingots
Classification
| Country | Section | Category |
|---|---|---|
| CIS, Russia, Ukraine | Titanium, titanium alloys | Technical Titan |
Chemical composition
| Standard | Fe, % | Si, % | Ti, % | C, % | O, % | N, % | H, % |
|---|---|---|---|---|---|---|---|
| GOST 19807-91 | < 1.5 | < 0.15 | > 97.79 | < 0.1 | < 0.3 | < 0.15 | < 0.01 |
Information on suppliers
Mechanical properties at 20 °C
| Rolling | Standard | Size, mm | Tension | Classifiers | $$\sigma _{U}$$, $$MPa$$ | $$\psi$$, % | $$KCU\cdot 10^{3}$$, $$\frac{J}{m^2}$$ | d5, % | Treatment |
|---|---|---|---|---|---|---|---|---|---|
| The bar is annealed. | GOST 26492-85 | 590–930 | 17 | 250 | 8 |
Standards
| Standard | Description |
|---|---|
| GOST 19807-91 |
Description of chemical elements
| Element | Units of measurement | Description |
|---|---|---|
| Fe | % | Iron |
| Si | % | Silicon |
| Ti | % | Titan |
| C | % | Carbon |
| O | % | Oxygen |
| N | % | Nitrogen |
| H | % | Hydrogen |
Description of mechanical properties
| Parameter | Units of measurement | Description |
|---|---|---|
| d5 | % | Elongation at break |
| $$\sigma _{U}$$ | $$MPa$$ | Ultimate tensile strength |
| $$\psi$$ | % | Reduction in cross section on fracture |
| $$KCU\cdot 10^{3}$$ | $$\frac{J}{m^2}$$ | Impact toughness |