NP2

Its chemical equipment in the production of liquid chlorine, caustic soda, fluorine, etc. at t -70, + 500 degrees. Basically sheets, plates. 8900kg / m3

for the manufacture of semi-finished products (wire, rods, strips, sheets and strip) used in mechanical engineering and instrumentation

Classification

Country Section Category
CIS, Russia, Ukraine Nickel, nickel alloys Prefabricated Nickel

Chemical composition

Standard Fe, % Si, % Sn, % Mg, % Bi, % Mn, % Cu, % Zn, % Sb, % Pb, % As, % Cd, % P, % C, % S, % Ni + Co, %
GOST 492-2006 < 0.1 < 0.15 < 0.002 < 0.1 < 0.002 < 0.05 < 0.1 < 0.007 < 0.002 < 0.002 < 0.002 < 0.002 < 0.002 < 0.1 < 0.005 < 99.5

Information on suppliers

Mechanical properties at 20 °C

Rolling Standard Size, mm Tension Classifiers $$\sigma _{U}$$, $$MPa$$ $$\epsilon_L$$, % Treatment
Sheet hot rolling 370 15
Sheet soft 370 35
Sheet solid 540 2
Round hot rolling 440 10
Round soft 370 30
Round solid 540 5
Tape soft 390 35
Tape solid 540 3

Casting and technological parameters

melting point, °C linear shrinkage, % the temperature of the casting, °C Hot working temperature, °C annealing temperature, °C
1455 1 1550–1650 1140–1250 700–800

Analogues

Standards

Description of chemical elements

Element Units of measurement Description
Fe % Iron
Si % Silicon
Sn % Tin
Mg % Magnesium
Bi % Bismuth
Mn % Manganese
Cu % Copper
Zn % Zinc
Sb % Antimony
Pb % Lead
As % Arsenic
Cd % Cadmium
P % Phosphorus
C % Carbon
S % Sulfur
Ni + Co % Nickel + Cobalt

Description of mechanical properties

Parameter Units of measurement Description
$$\sigma _{U}$$ $$MPa$$ Ultimate tensile strength
$$\epsilon_L$$ % Elongation at break (longitudinal)

Description of the casting and technological parameters

Parameter Units of measurement Description
melting point °C The temperature at which solid crystalline body makes the transition to the liquid state and Vice versa
linear shrinkage % The difference between model dimensions and the model casting
the temperature of the casting °C The temperature of the molten polymer is extruded from the heating cylinder into the mold
Hot working temperature °C The temperature at which the plastic-deformed metal recrystallizes during the pressure treatment
annealing temperature °C The temperature at which the processes return recrystallization and homogenization of the metal to reduce its hardness for subsequent machining